Storm Blanket - Made to Order
This cover has been matched to your vehicle as the standard model without aftermarket exterior accessories. The length of this cover is 640cm.
Our Storm Blankets are made to order. They are suitable for short-term use and with short notice of inclement weather approaching.
The Stormcovers triple layer technology used in Storm Blankets, ensures they are one of the toughest and most durable covers available on the market. They are made right here in Australia and are manufactured for harsh Australian conditions.
Installation of a Storm Blanket is fast and easy.
Tried and tested since 2007 - Stormcovers are backed by a trusted warranty.
- Storm Blanket Overall Length 640cm
- Protect your vehicle from damaging hail with a waterproof Storm Blanket
- Storm Blankets can be kept in your car boot and quickly applied in minutes wherever you are when hail is threatening
- Locally Australian Made
- Hand Crafted
- Warranty - 5 Year Warranty
Description
Product Information
Stormcovers have a Tyvek® inner layer that can easily rip when dragged over sharp edges. The Tyvek® protects the foam and the vehicle/RV that the cover is applied to from compromising the integrity of the outer layer; the Tyvek® and inner foam layer must be maintained so the outer layer can reach full life expectancy. TheTyvek® layer can easily be repaired or reinforced using packaging tape.
The inner Tyvek® layer is non-abrasive but because of the rigid structure of Stormcover components, it is possible that the cover could rub on your vehicle/RV sides when windy conditions persist. This could be a problem if your vehicle/RV is old and already has UV damage to powder or gel coatings. If you polish your vehicle/RV to achieve a shiny effect, you may find that the Stormcover could make the glossy sheen lose some of its lustre, so please consider this before choosing a Stormcover.
Stormcovers Blankets are made with a width of 2500mm (250cm).
If you place an order for a Stormcover, you are entering into a contract whereby you appoint Stormcovers Australia to manufacture a cover specifically for you in the standard design that we usually use. We will not be held responsible for Stormcovers that do not fit due to incorrect measurements being provided and any alterations will be charged on a time and cost basis at our discretion.
We endeavour to cross-check all measurements that are provided to us but it is important that you provide the actual measurements and not add anything onto the length as this will cause the pattern to become distorted and the cover made incorrectly. We will adjust sizing and pattern shaping where appropriate.
Patterns are cut by hand and are not CAD software or machine-cut therefore some discrepancies can occur with the shaping on each side (only by a very small amount, if at all).
